UBI EasyCoder 201 II Specifiche Scaricare il pdf (Pagina 260)

Appendix E— Using Direct Graphics Mode

244 IPL Programmer’s Reference Manual

Raw Bitmap Data Follows

Purpose: Indicates raw bitmap data bytes follow.

Syntax: 0x27[data]

Notes: The printer only uses the first 7 bits of the data byte. If you set a bit to 1,

it prints black. The most significant bit prints farthest to the left. Data

order runs from right to left, so the first dot in a column is the least

significant bit of the first data byte.

Repeat Last Line

Purpose: Causes the printer to copy the previously defined column n number of

times.

Syntax: 0x24n

Values for n range from 0 - 8191.

Notes: The printer automatically increments the X origin of each column. This

command is only valid when preceded by a column of encoded, raw data

or an end of line command.

Transition Black

Purpose: Transition data follows. The first transition is black.

Syntax: 0x25[data,data,...data]

where data specifies the number of black or white dots. Values for data can

range from 0 - 8191.

Notes: Each transition data specifies the number of dots to draw (either black or

white). Each data alternates black and white dot counts.

Transition White

Purpose: Transition data follows. The first transition is white.

Syntax: 0x26[data,data,...data]

Where data specifies the number of black or white dots. Values for data

can range from 0 - 8191.

Notes: Each transition data specifies the number of dots to draw (either black or

white). Each data alternates black and white dot counts.

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 269 270

Nessun commento

UBI EasyCoder 201 II Specifiche Pagina 260